Join Us and become a Member for a Verified Badge to access private areas with the latest PS4 PKGs.
PS3 Jailbreaking       Thread starter oner       5      
Status
Not open for further replies.

oner

Contributor
Hello guy,

my PS3 is CECHL04 and CFW REBUG 4.80.1 - COBRA 7.3 - TOOLBOX.

MY PROBLEMS are THESE:
- Recover mode; it's impossible to have a recovery mode. When press and hold the power on, nothing beep
(no single no dual), but only shutdown (red led after 2 min about);
- HDMI not work, only AV mode;
- It's impossible change original HDD 80Gb; when I remove it, my PS3 is dead, no video signal, no messages;

Can you help me?

Thanks (Pardon for my english)
 
Can you tell whole story ? why this happen what have u done to console ? have u try to use AV cable ?
Hy,
my stories is this. I'd used E3 flasher to downgrade OFW 4.80.
No problem during the process. Now the situation is this: no recovery mode, no hdmi, and no possibilty to install new HDD.
Why?
 
it's possible you could've bricked it. did you at least dump your backup of your NAND / NOR first before that happened? Also does it turn on?
 
it's possible you could've bricked it. did you at least dump your backup of your NAND / NOR first before that happened? Also does it turn on?
Hi,
yes I have the NOR dump, before downgrade. Why bricked? My PS3 work fine, multiman, and other pkg, games, video ecc. My problem isn't go in recovery mode and HDMI non signal (the HDMI-cable is good and HDMI-TV-port is OK). It's possible to call Recovery Mode from console?
 
Oh so you are tyring to go into recovery mode but you are trying to do so from the xmb?? you cannot do that! you must do it by holding the power button until it beeps keep pressing it until it beeps again. let go.. Then hold again until it beeps a third time / and fourth time closely together then let go. you will then be prompted to use a cable with the PS3 remote / or controller (connected) and to press the PS / Home Button once you do that use he option you need and there are lot's of videos on the subject but you'll also need to press start and select at the same time to get the function you want to use at the time to work. Do this after pressing X to select it. then press START AND SELECT TO BEGIN THE PROCESS also if you're having trouble with HDMI you might want to turn on Control For HDMI in the Settings! here's a video on how to do that. along with the recovery menu @oner :


 
Status
Not open for further replies.
Back
Top